28-6-2011 14 033000=13069F
4.1.1 Mounting the Door/Window Sensor DS18
1.) Open the casing by taking the two pieces apart. Mount the transmitter part on the frame
of your door or window. Do not close the casing yet.
2.) Mount the magnet on the moving part of your door of window. Make sure that the arrows
on the transmitter part (see the arrow!) and the magnet are facing each other when the door
or window is closed. Keep the distance between the transmitter part and the magnet (when
door or window is closed) as small as possible (max. 5 mm). Door/Window Sensors may be
hidden behind drapes for a more discreet installation.
If your window or doorframe is slightly countersunk, you can also place the transmitter part
and the magnet at a 90-degree angle. Once you have decided on a definite place for the
sensor, we advise to also fix the magnet with screws (included).
Aluminium/synthetic frames
Place the sensor as high as possible: This gives the best
range. Mark the place for the transmitter and the
magnet. Do not place the magnet directly on a metal
surface. In case of metal frames, or synthetic frames
with a metal core, place a piece of wood or plastic
(min. 5mm thick) between the magnet and the frame.
On metal frames the space between the sensor and
the magnet should be no more than 3mm when the
window or door is closed.
Sliding windows
In case of sliding windows the sensor and magnet
should NOT be allowed to slide along each other.
Place the sensor and magnet in such a way that when
closing the window the magnet and sensor approach
each other like in the picture on the right side.
4.1.2 Using the Door/Window Sensor
1. Open the casing by taking the two parts apart..
2. Insert batteries (2xAAA, alkaline) into the battery compartment. Observe polarity.
3. Set the switch for entry delay (5) to MIN when you have installed the sensor on a window
and on MAX when the sensor is installed on a door. When the switch is set to MAX, you have
time to open and close the door without triggering the alarm. If you want an instant alarm (on
e.g. the backdoor), set the switch to MIN.
4. Activate the sensor by pressing the tamper contact (6) on the transmitter for 4 seconds.
Release the button. The door/window sensor has now chosen a unique code, which can be
registered with your console.
4.1.3 Registering a Door/Window Sensor with the Console
1. To access the menu, press either the menu UP or DOWN button. The display now shows
ENTER PIN.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). The
display is cleared and shows a * for each number entered.
3. When the PIN code has been entered correctly, the word INSTALL will show up on the
display.
4. Press OK.
5. Open your door or window. The console will beep to confirm. The display will read ZONE 1
SET.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce